Monitoring / Control Module
Model No. FMS-REP
General
The monitoring / control module is designed to interface and monitor two – wire conventional detectors or call points, and provide flexible & quick response to emergency conditions. The monitoring function can supervises the power supply as well as the entire zone of devices, status conditions are reported as normal, open and alarm. The control function allows two Form C contacts for a variety of normally open and normally close contact applications such as fan operation, door closure, elevator recall and auxiliary control. Up to 300 modules can be placed on a single SLC loop, and the module’s address is easily set by DIP switch.
Features
- DCP protocol for fast and robust communication
- Use standard cable, no shielded or twisted pair required on SLC loop
- Up to 300 devices can be used on per loop
- One input contact monitor, provides up to 25 conventional smoke detectors
- Two Form C contracts, one is dry contact, the other is rated 2A@ 30VDC
- Address is easily to set by DIP switch
- End-of-line(EOL) devices is 10k Ohm resistor
Thông số kỹ thuật
| Operating Voltage | DC18V ~ 30V |
| Montior Current | 1.5mA (typical) @ DC 24V |
| Dòng báo động | 12mA (max) @ DC 24V |
| Alarm Temperature | Rise up to 30℃ during 30 seconds |
| LED indications | Normal：flash one time per 6 sec.
Alarm：always on Failure：flash 2 times per 6 sec. |
| Operating Temperature | -10℃ ~ 50℃ |
| Relative Humidity | <95% RH, non-condensing |
| EOL resistor | 10KΩ, 1/4W |
| Kích thước | Φ102*53mm |
